Wipes Insert
Wipes Insert
This purple object is designed to help better control the number of wet wipes that dispense from a pouch. When installed correctly this wipe regulator insert can release one wipe at a time. The following inserts are designed to work with:
- Costco Kirkland Signature Wipes
- Amazon Elements Wipes
- Huggies Wipes
To use this item: Kirkland Signature Wipes and Amazon Elements WIpes: With the insert facing up (arrow should be facing down) line up the bottom of the insert with the plastic edge of the opening and slide in the dirrection of the arrow. Take the top of the insert and gently press/squeeze the tab so that it captures the plastic edge of the opening. The insert should be secure with the grooves of the insert lining up with the plastic edge of the opening. To remove gently squeeze the top tab of the insert and pull up. (See photos). Huggies Wipes: With the insert facing up (arrow should be facing down) slide the bottom tab under the plastic ring and press the top tab into the plastic ring at the top. It should pop in place and hold in the plastic ring using the tabs.
Designed and fabricated in Washington State by AdaptedDesign.
[Please note that this item or parts of it are 3D printed and assembled by hand. This is not a mass produced item and may come with imperfections inherent in the 3D printing process. If the tool or device is not used as intended then it may not work properly or break. (TLDR: be gentle these are not indestructible). If you have any issues with your 3D printed item please contact AdaptedDesign and I will work with you on a solution. Other items shown in the listing photos are for suggested use and reference but are not included. If you have any questions with regard to 3D printed items and quality please reach out before ordering. Pricing is based on how long it takes to 3D print each item and is comparable to similar items being sold by similar shops. This shop was created to help raise funds for my child's medical expenses. Thank you for supporting my work here at AdaptedDesign.]
Share
You may also like
-
xSwitch Adapted Items
Regular price From $0.01 USDRegular priceUnit price / per$36.00 USDSale price From $0.01 USDSale -
Adapting Guide: Let's Adapt for Everyone!
Regular price $25.00 USDRegular priceUnit price / per -
Suction Machine Tip Holder
Regular price From $10.00 USDRegular priceUnit price / per$11.99 USDSale price From $10.00 USDSale -
Feeding Tube Extension Cap
Regular price From $10.00 USDRegular priceUnit price / per$12.99 USDSale price From $10.00 USDSale